General International 50-200R M1 Use and Care Manual download pdf (Page 22)

ADJUSTING THE BEVEL ANGLE POINTER

The bevel pointer should read “0” when the blade is at 90° to the table. If not, with the blade set 90° vertical to the

table, proceed as follows:

1. Remove the handwheel by loosening the hand

wheel lock knob A.

2. Once the handwheel has been removed, loosen

the Phillips head screw B on the pointer mounting

bracket with a screwdriver and manually align the

pointer C with the zero on the bevel scale, then re-

tighten the screw and re-attach the handwheel.

Notes

1 ... 21 22 23 ... 32

No comments

General International 50-200R M1 Use and Care Manual Page 22