General International 50-200R M1 Use and Care Manual download pdf (Page 10)

INSTALL THE TABLE EXTENSION WINGS

ttach the table extension wings to the main table

using 6 hex head bolts (3 per wing) and 6 lock wash-

ers A. Align the table extensions with the table and

oosely attach the bolts. Place a straightedge on the

table and extension as shown to align the extension

table B and then tighten down the bolts.

Note: Be sure that the table extension wings are flush with

front edge of table

level here

flush here

ASSEMBLY INSTRUCTIONS

INSTALL THE HANDWHEELS

1. Install one handwheel onto the shaft at the front of the

saw as shown in A.

Note: The slots in the handwheel must be aligned with the

spring pin on the shaft.

2. Thread a lock knob B into the handwheel shaft to

secure the handwheel in place.

3. Repeat with the second handwheel, on the shaft loca-

ted on the right side of the saw cabinet, C.

SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE

OMPLETED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

NSTRUCTED TO DO SO.

INSTALL THE REAR FENCE RAIL

Attach the rear rail to the rear of the table using 4 cap screws, 2 flat washers and 2 hex nuts A (1 screw with washer

and nut and both extension wings, B, and 2 cap screws on the main table C. Tighten with the supplied 6 mm Allen

key.

Install the fence storage brackets A (the two larger

ones) on the left side of the saw as shown in B, using 4

Phillips head screws C.

Install the miter gauge storage bracket A (the smaller

one) and arbor wrench storage bracket B on the right

side of the saw as shown in C, using 2 Phillips head

screws D per bracket.

MOUNT THE RIP FENCE STORAGE BRACKETS

MOUNT THE MITER GAUGE & ARBOR WRENCH STORAGEBRACKETS

CLOSE UP

1 ... 9 10 11 ... 32

No comments

General International 50-200R M1 Use and Care Manual Page 10