General International 75-260 M1 Use and Care Manual

SETUP & OPERATION MANUALMODEL#75-260 M1VERSION 5 - REVISION 1 (November 29th, 2011) 78359110© Copyright General® International 201117" EXTEND

10Insert and hold the rack in the notch in the table bracketand slide the bracket and rack onto the columnuntil the rack bottoms out on the rack seat

Note: To facilitate chuck and arbor installation, flip thespring loaded chuck guard up.1. Slide the arbor into the quill assembly, flat end goes infir

ADJUSTMENTS & CONTROLS1. Loosen table lock handle .2. Turn the table height adjustment handle until thetable is at the desired height.3. Tighten t

POWER “ON”VERIFY ALL FOLLOWING CHECK POINTS BEFORE TURNING ON THE DRILL PRESS. FAILURE TO COMPLY CAN RESULT INSERIOUS INJURIES.CHANGING SPEEDSMAKE SUR

INSTALL A DRILL BITBASIC OPERATIONS1. Lift up the chuck guard to keep it out of the way.2. Insert the chuck key and turn counterclockwiseto open the c

Abrasive sleevesitem 70-03010 piece replacementabrasive sleeve set for70-025. Includes 5 (one ofeach size) 80 & 120 gritsanding sleeves.Drill pres

STOPLINTERNATINALGENERAL123469091939284949587912111066646562716970838182807989887678779613149899103100101102171615188786737274751959616058575655464145

17PARTS LIST75-260 M175260-01 BASE 175260-02 WASHER 475260-03 HEX HEAD BOLT 475260-04 FLANGE 175260-05N COLUMN RACK 175260-06 COLUMN 175260-07 HANDLE

18PARTS LIST75-260 M175260-53 COVER LOCK SCREW 175260-54 PULLEY COVER 175260-55 PULLEY LOCK NUT 175260-56 SPINDLE PULLEY 175260-57 SPINDLE DRIVER KEY

19NOTES75260-107 CHUCK GUARD 175260-108 RACK RING 175260-109 RACK HOLDER 175260-110 BOLT HEX. HEAD M4 175260-111 SET SCREW M10 275260-112 SPACER 2PART

THANK YOU for choosing this General®International model 75-260 M1 17” 17”extended stroke drill press. This drill press has been carefully tested and i

IMPORTANTWhen ordering replacement parts, always give the model number, serial number of the machine andpart number. Also a brief description of each

GENERAL®& GENERAL®INTERNATIONAL WARRANTYAll component parts of General®, General® International and Excalibur by GeneralInternational ® products a

TABLE OF CONTENTSRules for safe operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

RULES FOR SAFE OPERATIONTo help ensure safe operation, please take a moment to learn the machine’s applications andlimitations, as well as poten-tial

ELECTRICAL REQUIREMENTSGROUNDING INSTRUCTIONSIn the event of an electrical malfunction or short circuit,grounding reduces the risk of electric shock.

17” EXTENDED STROKE DRILL PRESS75-260 M1IDENTIFICATION OF MAIN PARTS AND COMPONENTSA-PULLEY CASE COVERB - ON/OFF SWITCHC - CHUCK GUARDD - CHUCKE - COL

UNPACKINGCarefully unpack and remove the drill press componentsfrom the box and check for damaged or missing items asper the list of contents below.NO

9PLACEMENT WITHIN THE SHOP / ESTABLISHING A SAFETY ZONEPLACEMENT WITHIN THE SHOPThis machine should be installed and operated only ona solid, flat and