General International 75-155 M1 Use and Care Manual download pdf (Page 20)

OPERATING INSTRUCTIONS

CHECKLIST BEFORE STARTING

• Make sure the pulley cover is closed.

• Check that the chuck is installed properly.

• Make sure the chuck guard is securely installed and closed properly.

• When turning the machine “ON” be aware that the shaft will rotate freely.

• When the drill press is running check to see if it runs without vibration or shaking.

• Make sure the table bracket moves up and down smoothly.

• Make sure the spindle shaft turns smoothly.

VERIFY ALL CHECK POINTS BEFORE STARTING. FAILURE TO COMPLY CAN RESULT IN SERIOUS INJURIES.

1. Lift the chuck guard as shown and install a drill bit

suitable for the type of material to drill.

3. Secure the workpiece in a vise (optional).

5. Turn ON the machine and adjust the speed.

2. Flip the chuck guard down in place as shown.

4. For precision drilling use the laser pointer A to lo-

cate the drilling point on the workpiece.

6. Use the downfeed handles to lower the bit into the

workpiece.

DRILLING STEP-BY-STEP

1 ... 19 20 21 ... 32

No comments

General International 75-155 M1 Use and Care Manual Page 20