General International DP2001 Use and Care Manual download pdf (Page 5)

English

150326

12. ENSURE KEYS AND ADJUSTING WRENCHES ARE REMOVED

before turning power on. Left attached, these parts can y off a

rotating part and result in personal injury.

13. MAKE SURE THAT SWITCH IS IN “OFF” POSITION

before plugging in cord to reduce the risk of unintentional starts.

14. MAKE SURE TOOL IS PROPERLY GROUNDED.

If tool is equipped with three-prong plug, it should be plugged into a

three-pole electrical receptacle. Never remove the third prong.

15. NEVER STAND ON TOOL

Serious injury could occur if the tool is tipped or if the cutting tool is

unintentionally contacted.

16. KEEP HANDS WELL AWAY FROM ABRASIVE SURFACES

and all moving parts. Do not clear chips and sawdust away with

hands. Use a brush.

17. WHENEVER POSSIBLE USE A DUST COLLECTOR

with shaving hood to minimize health hazards.

18. SECURE WORK.

Use clamps or a vise to hold the work. It’s safer than using your hands

and it frees both hands to operate the tool.

19. DISCONNNECT THE PLUG FROM POWER

before making any adjustments. Changing attachments or accessories

can be dangerous if the tool could accidentally start.

TOOL SAFETY

1. MAKE SURE ALL DRILLING TOOLS

are moving at operation speed before feeding.

2. DO NOT FEED THE MATERIAL TOO QUICKLY.

The tool will perform better and be safer working at the rate for which it

was designed.

3. NEVER LEAVE THE MACHINE WITH THE POWER ON.

4. DO NOT FORCE THE MACHINE.

It will do the job better and be safer at a rate for which it was designed.

Don’t force a small tool or attachment to do the work of a larger

industrial tool. Don’t use a tool for a purpose for which it was not

intended.

5. MAINTAIN TOOLS WITH CARE.

Keep tools sharp and clean for better and safer performance. Follow

instructions for lubricating and safe performance. Follow instructions

for lubricating and changing accessories. Keep handles dry, clean and

free from oil and grease.

6. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY

ADJUSTMENTS.

Changing attachments or accessories can be dangerous if the tool

could accidentally start.

7. AVOID UNINTENTIONAL STARTING.

Be sure the switch is in the OFF position before plugging in. Do not

carry the tool with the power connected and your nger on the trigger.

8. KEEP GUARDS IN PLACE,

in working order, in good adjustment and alignment.

9. DO NOT USE THE TOOL

if it cannot be switched on or off. Have your tool repaired before using

it.

10. CHECK FOR DAMAGED PARTS.

Before using this tool, any part that is damaged should be carefully

checked to determine that it will operate properly and perform its

intended function. Check for alignment of moving parts, binding of

moving parts, breakage of parts, mountings, and other conditions that

may affect its operation. Inspect screws and tighten any ones that

are loose. Any part that is damaged should be properly repaired or

replaced by an authorized service center unless otherwise indicated

elsewhere in the instruction manual. Have defective switches replaced

by an authorized service center. Don’t use the tool if switch does not

turn it on and off properly.

1 2 3 4 5 6 7 8 9 10 ... 35 36

Comments to this Manuals

No comments

General International DP2001 Use and Care Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools General International DP2001