General International DP2001 Use and Care Manual download pdf (Page 14)

English

DRILL BIT

6. Insert the drill bit into the chuck (K, g 3) far enough to obtain maximum

grip from the chuck jaws. Make sure the drill bit is centered in the chuck.

7. Insert the chuck key (L, g 2) and turn it clockwise to tighten (and

counter-clockwise to loosen) the drill bit. Tighten the chuck sufciently to

prevent the bit slipping in the jaws during drilling. As a test, turn the drill

press on and immediately off to check if the drill bit wobbles.

TABLE ADJUSTMENT

8. To position the table (H, g 2) vertically, loosen the support lock handle

(B, g 2) and raise or lower the table to the desired position. Re-tighten

the support lock handle.

9. Line up the drill bit with the table center hole when through-boring to

avoid damage to the table.

10. To tilt the table, loosen the table bevel lock screw (G, g 2) under the

table, tilt the table to the desired angle (you can use the bevel scale on

the support as a rough gauge) and re-tighten the table bevel lock screw.

NOTE: It is a good idea to always check that the angle is correct with a

protactor or a combination square.

DEPTH CONTROL

11. The drilling depth may be controlled by watching the indicator and

depth scale (V g 3), on the left side of the drill press head, or it can be

regulated quite precisely by setting the depth stop nuts on the depth

stop rod (Q, g 3).

12. Check that the chuck key is not in the chuck and that the drill bit is

not contacting the workpiece. Check that the workpiece is properly

anchored on the table. Be sure that all the safety rules at the front of this

manual are followed.

LASER

13. Place a work piece on the table.

14. Turn the laser switch to the on (I) position.

15. Lower the drill bit to meet the work piece. The two laser lines should

cross where the drill meets the work piece.

16. If the laser needs to be adjusted:

● Using a hex wrench, turn the laser adjustment hex screws (3)

counterclockwise.

● Move the laser light housing until the two lines intersect where the drill

meets the work piece. DO NOT stare directly at the laser lines.

● Re-tighten the adjustment hex screws .

DRILLING

17. Turn the switch on.

18. Use the feed handles to push the drill bit slowly into the material.

Particularly in wood drilling, ease up on the pressure when nearing

the point where the drill bit is about to emerge on the other side of the

workpiece.

19. After drilling a hole, do not release the feed handle but restrain it lightly,

allowing the spring to raise spindle sleeve gently to its original position.

20. Turn off the drill press.

21. Switch off the laser.

WARNING! After switching off, never leave the machine unattended

until it has come to a complete stop.

WARNING! In case of any trouble or abnormal noise arising during this

operation, stop the motor at once, unplug the machine from the power

source and nd out the cause. Do not resume until the problem has been

solved.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comments to this Manuals

No comments

General International DP2001 Use and Care Manual Page 14

Comments to this Manuals

Related products and manuals for Power tools General International DP2001