FEATURESHeavy duty cast-iron head, column andbase built for steady vibration free per-formance.Head slides on precision machined cast-iron dovetail wa
ASSEMBLY INSTRUCTIONSFor your convenience this mortiser is shipped from the factory partially assembled and requires only minimalassembly and set up b
1/2”1/4”5/16”3/8”11The unit is also supplied with 2 different sized chisel support bushing adapters allowing the user to installchisel and bit sets of
121. Lower the head to its maximum .2. Place a piece of taller stock (minimum 3”) against the fence .NOTE: Make sure you are using a piece of planed
The mortiser is equipped with a rocker style ON/OFF dust-proof switch located on the front left hand side of the mor-tiser head.- To start the mortis
6. With the fence now set to the correct front to back position, tighten the two fence locking levers to hold the fence in place.7.So that the chips a
1. While holding the head, loosen the two bolts ,using a 17 mm wrench.- To set the head 30° left:Tilt the head towards the left until the tilting brac
MAINTENANCEPERIODIC MAINTENANCE• Keep the machine clean and free of dust, and woodchips. Vacuum or brush off any loose debris and wipe down the machin
REQUIRED MAINTENANCELUBRICATIONKeep the column and both sides of the dovetail waywell lubricated and free of dust or debris. Clean andremove dust, de
RECOMMENDED OPTIONAL ACCESSORIESHere are some of the optional accessories available from your local General International dealer.For more information
151423252412060510091112-1221718554106520353383736394052463443424405335820530319211317-164633150073048085102324927046567727143707954782928684376737774
THANK YOUfor choosing this General®International model 75-050T M1 5/8”tilting head hollow chisel mortiser.This mortiser has been carefully tested and
PARTS LIST75-050T M1PART N0.75050T-01N75050T-0275050T-0375050T-0475050T-0575050T-0675050T-0775050T-0875050T-0975050T-1075050T-1175050T-1275050T- 12-17
21Notes
IMPORTANTWhen ordering replacement parts, always give the model number, serial number of the machine andpart number. Also a brief description of each
GENERAL®& GENERAL®INTERNATIONAL WARRANTYAll component parts of General®, General® International and Excalibur by GeneralInternational ® products a
TABLE OF CONTENTSRules for safe operation . . . . . . . . . . . . . . .5Electrical requirements . . . . . . . . . . . . . . .6Grounding instructions
RULES FOR SAFE OPERATIONTo help ensure safe operation, please take a moment to learn the machine’s applications and limitations, as well as poten-tial
ELECTRICAL REQUIREMENTS GROUNDING INSTRUCTIONSIn the event of an electrical malfunction or short circuit,grounding reduces the risk of electric shoc
5/8” TILTING HEAD HOLLOW CHISEL MORTISER75-050T M1IDENTIFICATION OF MAIN PARTS AND COMPONENTSLEFT SIDE VIEWDOWNFEED HANDLEMOTORON/OFF SWITCHGAS HEAD-C
UNPACKINGCarefully unpack and remove the mortiser and its com-ponents from the box and check for damaged or miss-ing items as per the list of contents
CLEAN UPClean all rust protected surfaces by rubbing with a rag dipped in kerosene, mineral spirits or paint thinner. (Disposeof potentially flammable
Comments to this Manuals