General International 50-EXBC10 Use and Care Manual download pdf (Page 9)

Fig. 15

1. Attach the straight end of the diagonal braces to the tabs at the lower end of the boom mount support leg

using two 1/4” x 1/2” bolts, , lock washers, , and hex nuts . (Fig. 15)

2. Swing the diagonal braces into position on the underside of the extension table. (Fig. 16)

3. Mark the hole placement and drill suitable holes to accomodate bolts or woodscrews. (Not included)

4. Fasten the braces to the underside of the table. ( Fig. 17)

DIAGONAL BRACE INSTALLATION

FIT THE BOOM TO THE BOOM MOUNT CHANNEL

Fig. 16

Fig. 17

Fig. 18

1. Place the boom/hood assembly on the pivot pins located on the boom mount channel (Fig. 18) and swing the

arm over the table.

2. Secure the locking pin to hold the boom in position. (Fig.19).

3. Loosen the boom clamp knob and extend the boom to position the hood assembly over the blade.

(Fig. 20)

4. Lower the hood assembly into the down position over the blade (Fig. 21) and as needed, adjust the boom

mount channel position to roughly center the hood assembly over the blade.

To tighten

Fig. 19

Fig. 20

Fig. 21

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

General International 50-EXBC10 Use and Care Manual Page 9