General International 50-EXBC10 Use and Care Manual download pdf (Page 8)

BOOM-MOUNT CHANNEL INSTALLATION

1. Set the boom mount channel against the edge of your extension table, lining up the mounting pin on the

boom mount with the center of the blade . (Fig. 11)

Note: Because the slots in the boom mount channel are elongated - allowing for fine tuning later, perfect

alignment is not critical at this stage.

2. With a pencil, mark the hole placement in the table apron at the center of each mounting slot in the boom

mount channel. (Fig. 12)

Note: If your current extension table includes corner support legs, the legs may need to be removed if they

interfere with the hole placement for the boom mount channel.

Using less than 4 slots (2 at each end) is not recommended and can lead to system failure and seri-

ous personal injury.

Fig.11

TOP VIEW

3. Set the boom mount channel aside and drill through-holes in the extension table apron. (Fig. 13)

4. Secure the boom mount channel to the extension table using the supplied mounting hardware in the order

shown. (Fig. 14)

Note: The supplied mounting hardware will accomodate a typical installation with a table apron of up to

3/4” thick. For thicker aprons, longer bolts (not supplied) may be required.

Fig.12

Fig.13

BOOM MOUNT CHANNEL

Mounting Pin

Mounting Slot

ORDER OF ASSEMBLY

Fig.14

Boom Mount Channel

Table Apron

Note: For ideal installation, use bolts in all 6 mounting slots.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

General International 50-EXBC10 Use and Care Manual Page 8