General International 50-EXBC10 Use and Care Manual download pdf (Page 10)

5. Tighten the mounting bolts and secure the boom mount channel in position on the extension table. (Fig.22)

6. If you notice any sag or if the extension table is not level with the main table, adjust the height of the support

leg (Fig. 23, ) to support the added weight of the boom/hood assembly.

7. The diagonal braces can be tightened or loosened to allow the boom assembly to be levelled as needed by

adjusting the nuts on the eye bolt. (Fig. 23)

Fig. 22

Fig. 23

ADJUSTMENTS

1. The resistance or balance of the swing arm assembly can be

adjusted with the spring knob located on the rear of the swing

arm assembly. (Fig. 24)

2. The hood may be locked in any position by tightening the

hood lock handle located on the right side of the hood.

(Fig. 25)

Note: It is recommended the hood be locked in the upper posi-

tion when removing or swinging the boom and hood assembly

from the saw.

3. The length of the telescoping boom may be adjusted by loos-

ening the boom clamp knob and sliding the inner boom

in or out as required. (Fig. 26)

Note: Do not over-tighten the clamp knob. It takes little pres-

sure to clamp the boom securely.

Fig. 24

Fig. 25

Fig. 26

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

General International 50-EXBC10 Use and Care Manual Page 10