General International 50-EXBC10 Use and Care Manual download pdf (Page 11)

4. The bottom lock knob located on the boom mount channel

may need to be adjusted. Loosen the lock nut on the

threaded lock pin and turn the handle in the desired direction

to tighten or loosen the lock. (Fig. 27)

Note: The pin needs to swing just past center to lock properly.

5. To remove the boom assembly from the saw, release the lock

pin (Fig. 28), swing the boom assembly back and lift it off the

pivot pins. (Fig. 29)

Fig. 28

Fig. 29

CONNECTING TO A DUST COLLECTOR

Fig. 31

BEFORE STARTING THE TABLE SAW, CONNECT TO A DUST COLLECTION SYSTEM.

ALWAYS TURN ON THE DUST COLLECTOR BEFORE STARTING THE TABLE SAW AND ALWAYS STOP THE TABLE

SAW BEFORE TURNING OFF THE DUST COLLECTOR.

• Connect a 4” dust hose (not included) from your dust col-

lector to the bottom of the boom assembly. (Fig. 31)

• Check that all connections are sealed tightly to minimize

airborne dust.

• If you do not already own a dust collection system consider

contacting your GENERAL® INTERNATIONAL distributor for

information on our complete line of dust collection systems

or visit our Web Site at: www.general.ca

Fig. 27

PARALLEL BOOM ADJUSTMENT

1. Adjust the hex head stop bolt in or out as needed to align

the boom parallel to the front and back edges of the saw.

(FIG. 30)

2. With the boom alignment set, tighten down on the nut to

secure the bolt in place.

Fig. 30

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

General International 50-EXBC10 Use and Care Manual Page 11