FEATURESRouter lift for Excalibur cast-iron tables#40-070 and #40-075, MDF tables #40-047and #40-049 & phenolic tables #40-043and #40-045.Heavy-du
TENSIONING THE DRIVE CHAIN1. Lower the lift to its lowest position and then removeit from the table.2. Using a 6 mm allen key loosen the cap screw A(F
198308A248B252529134014122352252252322720122912272612109293220122620112026273636163816381515351821181533153363973137344281723262711Router lift(#40-125
PARTS LIST – #40-125NOTES:PART NO. REF. N0. DESCRIPTION SPECIFICATIONS QTY40125-01 60800001A ALUMINUM CARRIAGE BRACKET 140125-02 60500002 MAIN GEAR SH
NOTES:13
IMPORTANTWhen ordering replacement parts, always give the model number, serial number of the machine andpart number. Also a brief description of each
THANK YOU for choosing this Excalibur by General®International model#40-125 Router Lift. This router lift has been carefully tested and inspected befo
GENERAL®& GENERAL®INTERNATIONAL WARRANTYAll component parts of General®, General® International and Excalibur by GeneralInternational ® products a
1. Make sure that the operator has been properlytrained and has read and understands the Owner’sManual before operating any machinery.2. Be sure to re
IDENTIFICATION OF MAIN PARTS AND COMPONENTSA- CLAMPING BOLTB- CLAMPING BRACKETC- CHAIND- INSERT RING WRENCHE- STARTING PINF- CRANK HANDLEG- POSTS/SCRE
ASSEMBLY INSTRUCTIONS -PREPARE THE TABLE * FOR ROUTER LIFTSERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YO
This model 40-125 “fixed base” router lift, A is designed toaccommodate the largest diameter router motor bodycurrently available.Note: Based on our r
Note: When mounting the Milwaukee model 5625/5626motor, please ensure that a shim D is between the routerand the clamping surface of the lift.5. Slide
3. With the router plate leveled to the table,lock the platein place using the two supplied hex socket head screwsC in the threaded holes on both side
Comments to this Manuals