General International 30-460HC M2 Use and Care Manual download pdf (Page 4)

INSTALLATION

1. Remove the fastening bolts from the machine to the shipping skid.

2. Two lifting lugs are built into the machine, one of which is illus-

trated in (Fig.3,A). These lugs can be used to mechanically lift the

machine using a forklift and lifting straps.

Note: The second lifting lug is located at the back opposite end of the

machine.

3. Table can be lowered (Fig.3,B) to facilitate cleaning, loosen lock

knob (C) and turn handwheel (D) counter-clockwise until the table

(B) is at the desired height for cleaning.

4. Loosen and remove screw from the top edge of the

machine (Fig4,E). Raise the top cover as illustrated in (Fig.5,F)

this step will expose the chipbreakers, and the cutterhead. Note: The

t op c o v er of the machine is hinged to facilitate cleaning and adjustment

procedures

5. Carefully remove the protective coating from the table, table rolls,

infeed roll, anti-kickback fingers, cutterhead and cutterhead knives.

This protective coating may be removed with a soft cloth moistened

with kerosene.

• Never attempt to use Gasoline, Acetone or Lacquer thinner, these

products will damage any painted areas.

• Caution: Extreme care should be taken when cleaning the knives,

as the cutterhead knives are extremely sharp.

6. After cleaning, cover the table surface with a layer of quality

paste wax.

7. Lower top cover and replace locking screw that was removed in

step 4.

ASSEMBLING HANDWHEEL HANDLE

Thread handle assembly (A) Fig.6 into handwheel (B) and tighten locknut

(C).

ASSEMBLING CUTTERHEAD GUARD

Position the cutterhead guard (A) Fig.7, on the top cover of machine.

Align holes in cutterhead guard with holes in top cover and fasten with

(six) 6mm-button head screws (B) as illustrated in Fig.7

◊

FIG. 3

FIG. 5

FIG. 4

FIG. 7FIG. 6

1 2 3 4 5 ... 38

No comments

General International 30-460HC M2 Use and Care Manual Page 4