General International 30-460HC M2 Use and Care Manual download pdf (Page 3)

GENERAL® INTERNATIONAL industrial planers are carefully tested and inspected

before shipment and if properly used will give perfect results. However, a reason-

able amount of care and attention is necessary to ensure perfect performance and

accurate work. It is imperative that you take a few moments to familiarise yourself

with these instructions, as they will no doubt save you a lot of time and trouble.

UNPACKING AND CLEANUP

To ensure maximum performance from your GENERAL® INTERNATIONAL 24» industrial planer 30-460, clean it

properly; and install it accurately before use. As soon as you receive the planer, we recommend you follow these

procedures:

1. The 24» planer is shipped in one container mounted to a shipping skid. Remove the wooden crate from

around the machine. The planer is shipped with the motor, motor pulley and belts assembled to the machine.

2. Finish removing the contents of the shipping crate and compare with the contents list.(Fig.2)

3. Report damage, if any to your local distributor.

4. Clean all rust protected surfaces with a mild solvent or kerosene. Do not use lacquer thinner; paint thinner, or

gasoline. These will damage painted surfaces.

5. To prevent rust, apply a light coating of paste wax to surface.

24» INDUSTRIAL PLANER

VARIABLE FEED SPEED

30-460

A. CUTTERHEAD GUARD

B. DUST HOOD

C. SAFETY HANDLE

D. KNIFE SETTING GAUGE

E. 12 X 14MM OPEN END WRENCH

F. 10 X 8MM OPEN END WRENCH

G. T-HANDLE WRENCH

H. ALLEN WRENCH (4MM)

I. ALLEN WRENCH (5MM)

J. ALLEN WRENCH (6MM)

CONTENTS LIST - Fig.2

1 2 3 4 5 6 7 8 ... 37 38

No comments

General International 30-460HC M2 Use and Care Manual Page 3