General International 75-500 M1 Use and Care Manual

SETUP & OPERATION MANUALVersion #2_Revision #1 - (S/NO 79941914) March 28, 2014 © Copyright General International22" PRESS DRILLMODEL#75-500F

101. Make sure the pulley guard is closed.2. Check that the chuck or keyless chuck is installed properly.3. Make sure the chuck guard is well inst

11TABLE TILT ADJUSTMENTDRILLINGDEPTH STOP ADJUSTMENT1. Loosen the nuts 4 and 5. 2. Tilt the table to the desired angle. 3. Retighten the nut

12CHANGING SPEEDS1. Disconnect the drill press from the power source.2. Loosen the two slides bar bolts 1 located on the right and left side of the

13MAINTENANCEPeriodically lubricate all sliding or moving parts includ-ing the column, rack and the quill shown (use any allpurpose grease, available

RECOMMENDED OPTIONAL ACCESSORIESHere is a sampling of optional accessories available from your local General International dealer to help you increase

PART # DESCRIPTION QTY70500-01 SPINDLE PULLEY 170500-02 NUT 170500-03 PULLEY COVER 170500-04 SCREW 170500-05 LOCK KNOB

PARTS LIST Press Drill (#75-500)IMPORTANT: When ordering replacement parts, always give the model number, serial number of the machine and part numbe

PART # DESCRIPTION QTY70500-102 CORD PROTECTOR 170500-103 CAPACITOR (NOT SHOWN) 170500-104 CAPACITOR COVER (NOT SHOWN) 170500-

DIAGRAM18

NOTES19

GENERAL® INTERNATIONAL8360 Champ-d’Eau, Montreal (Quebec) Canada H1P 1Y3Telephone (514) 326-1161 • Fax (514) 326-5555 • www.general.caDisclaimer: The

Follow us:8360 Champ-d’Eau, Montreal (Quebec) Canada H1P 1Y3Tel.: (514) 326-1161Fax: (514) 326-5565 - Parts & Service / (514) 326-5555 - Order Des

GENERAL® INTERNATIONAL WARRANTYAll component parts of General® International and Excalibur by General International® products are carefully inspected

TABLE OF CONTENTSRules for safe operation ... 5Elect

5RULES FOR SAFE OPERATION1. Do not operate the drill press when tired, distract-ed, or under the effects of drugs, alcohol or any medication that imp

6ELECTRICAL REQUIREMENTSBEFORE CONNECTING THE MACHINE TO THE POWER SOURCE, VERIFY THAT THE VOLTAGE OF YOUR POWER SUPPLY CORRESPONDS WITH THE VOLTAGE S

IDENTIFICATION OF MAIN PARTS AND COMPONENTS FRONT VIEW7A. BASEB. COLUMNC. TABLED. INTERLOCK CHUCK GUARDE. CHU

INSTALLATION This machine should be installed and operated only on a solid, flat and stable floor that is able to support the weight of the sander (372

9INSTALLING THE CHUCK GUARD ON THE HEADSTOCKvvvTO REDUCE THE RISK OF SERIOUS INJURY, ALWAYS COVER THE CHUCK AND DRILL BIT WITH THE CHUCK GUARD WHEN US