General International BS5205 Use and Care Manual download pdf (Page 11)

English

150311

A Band saw head assembly 1

B Leg assembly 2

C Tool tray 1

D Wheels 2

E Wheel frame 1

F Transport handle 1

G Worm gear pulley 1

H Motor shaft pulley 1

I V-belt 1

J Pulley cover 1

K Work stop rod 1

L Vertical cutting plate 1

M Vertical cutting support 1

N Accessory pack 1

ASSEMBLY PROCEDURE

WARNING! For your own safety, never connect the plug to the power

source outlet or insert the switch insert key until all the assembly steps

are complete and you have read and understood the entire owner's

manual.

STAND

Attach the lower tray, wheels and transport handle in this order:

1. Locate the two 2 leg assemblies (B, g 2 & 3).

2. Locate the tool tray (C, g 2).

3. On both leg assemblies, open the hinged ap 90 degrees. (g 3)

4. Place the two 2 leg assemblies about 18" (45 cm) apart.

5. Place the tool tray with the edges pointing up, between the 2 leg

assembies.

6. At each end, align the holes of the tool tray with the holes in the edge of

the leg assembly.

NOTE: the legs should t equally well either way around.

7. Locate 8 M6 washers, 4 M6 hexagon nuts and 4 M6 x 10 hexagon head

bolts.

8. Place a washer onto each M6 x 10 hexagon head bolt.

9. Fully insert 1 hex head bolt with washer rst, through each of the 4

holes of the tool tray, then the holes of the leg assembly.

10. Slide a washer onto the threaded ends of each hex head bolt.

11. Place a hex nut onto each bolt.

12. Be sure the stand is symetrical and stable.

13. Fully tighten the 4 hexagon nuts and bolts.

BAND SAW CONNECTINg PLATES

1. Locate the two connecting plates (GG, g 5) and place one connecting

plate on top of each leg assembly with the tabs inside.

2. Align the 3 bottom holes (b, g 5) of each connecting plate with the 3

holes at the tops of each leg assembly.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Comments to this Manuals

No comments

General International BS5205 Use and Care Manual Page 11

Comments to this Manuals

Related products and manuals for Power tools General International BS5205